Bizon Glass Hydrogel Front Motorola Moto G04/G24/G24 Power/E14 [2 PACK]
Quality of Bizon
The hydrogel film Bizon Glass Hydrogel Front is made of flexible, thermoplastic polyurethane. This product is suitable for protecting the phone screen from scratches and dirt. The film is created using modern technologies, such as Self Heal — which supports self-regeneration in case of minor scratches or air bubbles that disappear over time.
Dimensions of the Film
When selecting a case, make sure that the film is smaller than the internal dimensions of the case.
Film dimensions: 15.81 x 7.00 cm
Note! Depending on the device model, Bizon Glass Hydrogel Front may not be compatible with cases.
Product Functionality
The film is characterized by high transparency and maintained screen sensitivity. An additional advantage is coverage of almost the entire display with minimal margins. Bizon Glass Hydrogel is only 0.15 mm thick, making it thinner than tempered glass.
Contents of the Set
- film Bizon Glass Hydrogel Front – 2 pieces
- positioning stickers – 3 pieces
- application support card - 1 piece
- dry microfiber cloth – 1 piece
- wet cloth for screen cleaning – 2 pieces
- round sticker for picking up dust and particles (dust absorber) – 1 piece
Installation Instructions
- Ensure that the film is dedicated to the model of the phone you have.
- Clean the screen with a wet cloth and microfiber.
- Carefully examine the product, paying attention to the layers: matte white backing, positioning film, main film, and the outer protective layer.
- Remove the middle protective part of the positioning film, marked with number 1, and then rotate the film along the vertical edge.
- Make sure the film is oriented correctly and stick the middle part of the film to the screen – if it is applied crookedly, it can be peeled off and reapplied. This action is intended for proper positioning of the film, it is not the actual film.
- Lift and gently bend the shorter, lower part of the matte backing with the Bizon inscription so that it detaches from the film and, using the card, make one smooth motion down toward the bottom edge of the screen so that the film adheres properly.
- Perform the same action with the second, longer part of the film, remembering to detach it from the matte white backing. Slide the card across the screen to remove any remaining air bubbles. You can remove any dust particles using the round sticker (dust absorber).
- At the top of the screen, you will find a protruding end, grab it and thus remove the remaining protective layer. Done!
If air bubbles appear, they can be gently pushed outwards. Keep in mind that small bubbles will disappear within 24 hours.
Data sheet
Type | protective film |
---|---|
The number of pieces in the set | 2 |
Specific References
EAN13 | 5904665336847 |
---|---|
MPN | BGHS2MG04 |
Reviews
No customer reviews for the moment.