Bizon Glass Hydrogel Front Oppo A58 4G / A38 [2 PACK]

Bizon Quality

The hydrogel film Bizon Glass Hydrogel Front is made of flexible, thermoplastic polyurethane. The product is suitable for protecting the phone screen from scratches and dirt. The film is created using modern technologies such as Self Heal — which supports self-regeneration in case of minor scratches or disappearing air bubbles over time.

Film Dimensions

When choosing a case, it is important to ensure that the film is smaller than the internal dimensions of the case.

Film dimensions: 15.81 x 7.01 cm

Note! Depending on the device model, Bizon Glass Hydrogel Front may not be compatible with cases.

Product Functionality

The film features high transparency and maintained screen sensitivity. An additional advantage is the coverage of almost the entire display with minimal margin. Bizon Glass Hydrogel is only 0.15 mm thick, making it thinner than tempered glass.

Contents of the Set

• film Bizon Glass Hydrogel Front – 2 pieces
• positioning stickers – 3 pieces
• application support card - 1 piece
• dry microfiber cloth – 1 piece
• wet cloth for cleaning the screen – 2 pieces
• round sticker for picking up particles and dust (dust absorber) – 1 piece

Installation Instructions

1. Make sure that the film is dedicated to the model of the phone you own.
2. Clean the screen with a wet cloth and microfiber cloth.
3. Carefully examine the product, paying attention to the layers: matte white backing, positioning film, actual film, and outer protective layer.
4. Remove the central protective part of the positioning film, marked with number 1, then rotate the film along the vertical edge.
5. Ensure that the film is oriented correctly and stick the central part of the film to the screen – if it sticks unevenly, it can be peeled off and reapplied. This action is meant to properly position the film; it is not the actual film.
6. Lift and gently bend the shorter, lower part of the matte backing with the Bizon logo so that it detaches from the film, and using the card, in one smooth motion, swipe towards the bottom edge of the screen so that the film adheres properly.
7. Perform the same action with the second, longer part of the film, remembering to detach it from the matte white backing. Slide the card over the screen to remove any remaining air bubbles. You can remove any dust particles with the round sticker (dust absorber).
8. At the top of the screen, you will find a protruding end, grab it and thus remove the remaining protective layer. For phones with a rounded screen, remember to press the edges of the film only at the very end, after removing the protective layer. Done!

If air bubbles appear, they can be gently pushed outwards. Please keep in mind that small bubbles will disappear within 24 hours.