Bizon Glass Hydrogel Back Apple iPhone 15 Plus [2 PACK]

Bizon Quality

The hydrogel film Bizon Glass Hydrogel Back is made of flexible, thermoplastic polyurethane. The product will be effective for protecting the back panel of the phone from scratches and dirt. The film is created using modern technologies such as Self Heal — which supports self-regeneration in case of minor scratches or disappearing air bubbles over time.

Film Dimensions

When choosing a case, make sure that the film is smaller than the internal dimensions of the case.

Film dimensions: 15.76 x 7.45 cm

Note! Depending on the model of the device, Bizon Glass Hydrogel Back may not be compatible with cases.

Product Functionality

The film features high transparency and covers almost the entire back panel, with a cutout for the camera island. Bizon Glass Hydrogel is only 0.15 mm thick, making it thinner than tempered glass.

Contents of the Set

• film Bizon Glass Hydrogel Back – 2 pieces
• positioning stickers – 3 pieces
• application support card - 1 piece
• dry microfiber cloth – 1 piece
• wet screen cleaning cloth – 2 pieces
• round sticker for picking up dust and particles (dust absorber) – 1 piece

Installation Instructions

1. Make sure that the film is dedicated to the model of the phone you own.
2. Clean the back with the wet cloth and microfiber.
3. Carefully examine the product, paying attention to the layers: matte white backing, positioning film, actual film, and the outer protective layer.
4. Remove the middle protective part of the positioning film, marked with number 1, and then rotate the film along the vertical edge.
5. Make sure the film is aligned in the correct direction and stick the middle part of the film to the device – if it is applied crookedly, it can be peeled off and reapplied. This action aims to properly position the film; it is not the actual film.
6. Lift and gently bend the shorter, lower part of the matte backing with the Bizon inscription so that it separates from the film, and using the card, make one smooth motion towards the bottom edge of the phone to ensure the film adheres properly.
7. Perform the same action with the second, longer part of the film, remembering to detach it from the matte white backing. Slide the card over the back panel to remove any remaining air bubbles. You can remove any dust particles using the round sticker (dust absorber).
8. At the top of the screen, you will find a protruding end, grab it and thus remove the remaining protective layer. Done!

If air bubbles appear, they can be gently pushed outwards. Note that small bubbles will disappear within 24 hours.